![Image](http://i54.photobucket.com/albums/g117/Buz_Lactarius/Rosette/Redwood/Redwoodguitar033-1.jpg)
Made a cardboard cutout of the control space so I can set up the electronics outside the body.
![Image](http://i54.photobucket.com/albums/g117/Buz_Lactarius/Rosette/Redwood/Redwoodguitar036-1.jpg)
Gives you a general idea of the controls. I have not put the inputs in yet, nor the grounds or output. Will save these for when the controls are inside the guitar. I have the switching so it goes neck, both, bridge, piezo alone and piezo with neck. 3 volume controls and a master volume for the preamp. This is a tube preamp by Oatley in Australia. Read about it in Nuts and Volts magazine.
![Image](http://i54.photobucket.com/albums/g117/Buz_Lactarius/Rosette/Redwood/Redwoodguitar037-1.jpg)
View of the peghead and rounded fret ends. Also since the fingerboard binding was a bit narrow, I used some wire for fret markers.
![Image](http://i54.photobucket.com/albums/g117/Buz_Lactarius/Rosette/Redwood/Redwoodguitar040-1.jpg)
![Image](http://i54.photobucket.com/albums/g117/Buz_Lactarius/Rosette/Redwood/Redwoodguitar041-1.jpg)
Have started to use Tru-oil for this build.
![Image](http://i54.photobucket.com/albums/g117/Buz_Lactarius/Rosette/Redwood/Redwoodguitar039-1.jpg)
Mike Z