![Image](http://i531.photobucket.com/albums/dd354/tlguitars/LuthierForum/lf46.jpg)
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/LuthierForum/lf47.jpg)
Since my tops are dead flat I put the bevel in slightly above level to have some routing room.
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/LuthierForum/lf48.jpg)
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/LuthierForum/lf49.jpg)
After it dries I route and sand to my final profile.
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/LuthierForum/lf50.jpg)
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/LuthierForum/lf51.jpg)
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/LuthierForum/lf52.jpg)
Normally I would now reinsert the sides into my radius / profiling molds and take them back to spec with the router, like in my SC Prototype build, see below...
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/SC%20Prototype/c80.jpg)
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/SC%20Prototype/c81.jpg)
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/SC%20Prototype/c82.jpg)
![Image](http://i531.photobucket.com/albums/dd354/tlguitars/SC%20Prototype/c83.jpg)
But I have the backs glued in so it wouldn't fit into my molds. So I spent an hour + hand sanding and radius dish sanding, that sucked!!! Note to self, check your steps before moving forward!! I'll get it next time.